Subject Detection in Photo AI for both denoise and sharpening

Currently it appears that the subject detection only works on the sharpening feature in Photo AI, while the denoise feature is always over the entire image.

There are many times that parts of the image should not have the denoise or be selectively done at different levels. Please add the option for the subject selection/masking to also be used with the noise reduction.

Let’s try updating you to the most recent version release to see if this resolves the issue.

Please make sure you’ve also turned off any firewall, VPN, or proxy that may be on your computer. These are known to block the installation. Also, make sure there are no settings or configurations in your OS system that could interfere.

Try using the appropriate OS system link to update:

If you are still experiencing problems, please reach out to us at the following link:

Topaz Labs | Support Page

This is an issue in version 3.0 now.

There is no preference option to select which you prefer subject or back ground or all.

If you copy the settings from one image to another and have the subject denoise only selected this will not be applied to the set of images with Denoise the entire image being applied.

Try using a preset.

If you us a preset and then apply it to the next image by copying it (rather than going from image to image) then it resets to selecting the entire image to denoise and doesn’t apply the subject masking.

Save the preset then apply it.