Missing details and parameters in the CLI documentation

[ForSerious]

I’m trying to get nyx to work. Ideally I would be able to use relative to auto with the ability to set some of the parameters to ‘ignore auto and just stay at 0 no matter what’.
I’m doubting that kind of functionality has gone into the ‘relative to auto’ mode yet. It’s hard to know when there’s no details to be found in the command line interface documentation.
I have found that to get auto and relative to auto to activate, you must add ‘estimate=8’. Why 8? What will it do if I change that to 4?

Another little discrepancy. Auto changes the blur parameter, but there is no slider for ‘Sharpen’ in the GUI.

[20rushtonj (Alaska)]

@ForSerious

I have found that to get auto and relative to auto to activate, you must add ‘estimate=8’. Why 8? What will it do if I change that to 4?

I just wanted to add some information.

The estimate=X settings tells the filter to use Auto settings (or relative to Auto settings). The value X is the number of frames to look ahead and/or back to assist in predicting what values should be used. Changing the value from 8 to 4 will reduce the number of frames used in this prediction.

Note: In older versions of TVAI, and or other models, they use estimate=20.

Yes, this should be in the documentation.